comment on this article

Miniature microfluidics heat sink from imec

At this week's Embedded World in Nuremberg, Germany, imec presented a silicon-based compact microchannel heat sink that enables high heat flux dissipation.

The heat sink, attached to a high performance chip, is able to achieve a low total thermal resistance of 0,34K/W to 0.28K/W at less than 2 W pump power and uses silicon (Si) technology for fabricating microchannels.

According to imec, this chip cooler may be the answer for the heat challenge that the new generation of power electronics and systems in a Package are faced with.

The downscaling of integrated chips and their packaging is a major trend in the electronics industry. However, with ever-increasing power density comes detrimental heat effects that impact the reliability and performances of the devices. Liquid is more effective in removing
that heat compared to air, because of its higher thermal conductivity and specific heat capacity.

Silicon as a material is a relatively good heat conductor. so the use of small, parallel, high-aspect-ratio silicon microchannel structures of 32µm wide and more than 260µm deep in this chip cooler increases the convective heat transfer surface area and the heat transfer coefficient, enabling high heat flux removal. This makes it possible to dissipate power of more than 600W/cm2 while keeping the component temperature below 100°C.

According to imec, the key attribute of silicon is that it can realize high-aspect-ratio microstructures at low cost by leveraging massively parallel production processes and is directly integrable in the semiconductor manufacturing process.In the current version, the Si-based microchannel heat sinks are fabricated separately and then interfaced to the back side of
a heat-dissipating chip.

Using an optimised Cu/Sn-Au interface, imec has been able to achieve a very low thermal contact resistance between both parts.

Finally, since the fluidic performance and thermal behaviour can be predicted with high degree of accuracy, this microcooler can also be tailored according to external system constraints such as space and liquid supply.

Imec’s microfluidic heat sink realized on a Si platform is a best-in-class technology demonstrating the lowest thermal resistance allowing a power dissipation of over 600W/cm2 in a very small form factor. It allows for an increase in heat flux by two orders of magnitude compared to classical metal heat sinks,” said Philippe Soussan Principal Member of the technical staff. “Imec is working towards developing a next generation of this chip cooling solution, directly integrating the heat sinks and the IC at wafer scale, aiming at an additional cost of one USD.”

Author
Neil Tyler

Comment on this article


Websites

http://www.imec.be

Companies

IMEC

This material is protected by MA Business copyright See Terms and Conditions. One-off usage is permitted but bulk copying is not. For multiple copies contact the sales team.

What you think about this article:


Add your comments

Name
 
Email
 
Comments
 

Your comments/feedback may be edited prior to publishing. Not all entries will be published.
Please view our Terms and Conditions before leaving a comment.

Related Articles