comment on this article

Imec demonstrates fully monolithical co-integration of GaN half-bridge with drivers

imec has announced that it has demonstrated a functional GaN half-bridge monolithically integrated with drivers.

Mounted on a buck-convertor test board, the chip converts an input voltage of 48V to an output voltage of 1V, with a pulse width modulation signal of 1 MHz. The achievement looks to leverage on imec’s GaN-on-SOI and GaN-on-QST technology platforms, reducing parasitic inductance and boosting commutation speed.

At present, GaN power electronics tend to be dominated by off-the-shelf discrete components. Half-bridges, common sub-circuits in power systems, are fabricated by separate discrete components, either in separate packages, or integrated in one package, especially for the higher voltage ranges. Realising half-bridges on chip by using GaN-on-Si technology, is challenging, especially at high voltages and is because half-bridges designed on GaN-on-Si technology are limited in performance by a back-gating effect that negatively affects the high-side switch of the half-bridge, and switching noise that disturbs the control circuits.

To unlock their potential, imec has monolithically co-integrated a half-bridge and drivers in one GaN-IC chip. Complemented by low voltage logic transistors, a suite of passive components for low-ohmic and high-ohmic resistors, and a MIM-capacitor, high-end integrated power systems can be realized on one single die.

The solution builds on imec’s GaN-on-SOI and GaN-on-QST technology platforms that allow for a galvanic isolation of the power devices, drivers and control logic, by the buried oxide and oxide-filled deep trench isolation. This isolation scheme not only eliminates the detrimental back-gating effect that negatively affects the high-side switch of the half-bridge, but also reduces the switching noise that disturbs the control circuits. With the design of a co-integrated level shifter for driving the high-side switch, a dead-time controller to avoid overlapping gate input waveforms, and an on-chip pulse-width modulation circuit, highly integrated buck and boost convertors can be fabricated.

“Someone might think that by using SOI or QST wafers instead of Si wafers will result in more expensive technology. However, with GaN-on-Si several discrete devices need to be individually packaged (with advanced packages to take advance of the GaN fast switching performance) and connected to their drivers and other elements at the board or packaged level”, explained Denis Marcon, business development manager at imec.

“Instead, with imec’s GaN-IC technology, the full converter including drivers and analog blocks etc. is on-chip, which can then be packaged with simple package technology (as the frequency sensitive components are already connected on-chip). This dramatically saves on the cost of the final power system.”

To further boost the performance of these monolithic integrated power systems, imec is looking to extend its platform with additional co-integrated components, such as Schottky diodes and depletion-mode HEMTs.

“With the aim to further foster innovation in the GaN power electronics, this GaN-IC platform is available for prototyping through our multi-project-wafer (MPW) service”, said Stefaan Decoutere, program director GaN power electronics at imec.“The possibilities for high-end power systems with unprecedented performance, either in switching speed, operating frequency or energy efficiency, with reduced inductive parasitics and unseen reduction of the form-factors, will further boost the use of GaN for power supplies in the consumer and re-useable energy market segments.”

Author
Neil Tyler

Comment on this article


Websites

http://www.imec.be

Companies

IMEC

This material is protected by MA Business copyright See Terms and Conditions. One-off usage is permitted but bulk copying is not. For multiple copies contact the sales team.

What you think about this article:


Add your comments

Name
 
Email
 
Comments
 

Your comments/feedback may be edited prior to publishing. Not all entries will be published.
Please view our Terms and Conditions before leaving a comment.

Related Articles