comment on this article

CEA-Leti develops circuits for neuromorphic processors

Leti, a research institute at CEA Tech, has proven that RRAM-based ternary-content addressable memory (TCAM) circuits, featuring the most compact structure developed to date, can meet the performance and reliability requirements of multicore neuromorphic processors.

TCAM circuits provide a way to search large data sets using masks that indicate ranges and are, therefore, suitable for complex routing and big data applications, where an exact match is rarely necessary.

TCAM circuits allow searching for stored information by its content, as opposed to classic memory systems in which a memory cell’s stored information is retrieved by its physical address and so shorten the search time compared to classic memory-based search algorithms, as all the stored information is compared with the searched data in parallel, within a single clock cycle.

Conventional SRAM-based TCAM circuits are usually implemented with 16 CMOS transistors, which limits storage capacity of TCAMs to tens of Mbs in standard memory structures, and takes up valuable silicon real estate in neuromorphic computing spiking neural-network chips.

The breakthrough unveiled by the CEA-Leti project sees SRAM cells replaced with resistive-RAM (RRAM) in TCAM circuits to reduce the number of required transistors to two (2T), and to two RRAMs (2R), which is the most compact structure for these circuits produced to date. In addition, the RRAMs were fabricated on top of the transistors, which also consumed less area. This suggests such a 2T2R structure can decrease the required TCAM area by a factor of eight compared to the conventional 16-transistor TCAM structure.

But while using RRAMs in TCAM circuits significantly reduces both silicon chip area needed and power consumption, and guarantees similar search speed compared to CMOS-based TCAM circuits, this approach brings with it other challenges such as:

  • Circuit reliability is strongly dependent on the ratio between the ON and OFF states of the memory cells. RRAM-based TCAM reliability could be affected by the relatively low ON/OFF ratio (~10-100) with respect to the 16-transistor structure (~), and
  • RRAMs have a limited endurance with respect to CMOS transistors, which can affect the lifespan of the system.

Overcoming these challenges requires trade-offs. The voltage applied during a search operation can be decreased, which improves system reliability. However, this also degrades system performance, e.g. slower searches, and the limited endurance can be overcome by either decreasing the voltage applied during each search, or increasing the power used to program the TCAM cells beforehand. Both increase system endurance, while slowing searches.

The work was presented at IEDM 2018 in a paper entitled, “In-depth Characterization of Resistive Memory-based Ternary Content Addressable Memories”, and clarifies the link between RRAM electrical properties and TCAM performance with extensive characterizations of a fabricated RRAM-based circuit.

The research showed a trade-off exists between TCAM performance (search speed) and TCAM reliability (match/mismatch detection and search/read endurance) and provided insights into programming RRAM-based TCAM circuits for other applications, such as network packets routing.


Author
Neil Tyler

Comment on this article


Websites

http://www.leti-cea.com

Companies

CEA

This material is protected by MA Business copyright See Terms and Conditions. One-off usage is permitted but bulk copying is not. For multiple copies contact the sales team.

What you think about this article:


Add your comments

Name
 
Email
 
Comments
 

Your comments/feedback may be edited prior to publishing. Not all entries will be published.
Please view our Terms and Conditions before leaving a comment.

Related Articles